1.检查机台各部位是否正常；
2.根据派工单所需的加工要求，选择合适的研磨棒；
3.把研磨棒装在马达轴上；
4.把工件放在无心轴承上，并用无心轴承固定杆将工件夹住；
5.用千分表检查工件是否水平，如有斜度，用斜度调整螺钉将斜度调为0度；
6.打开无心轴承升降开关，用无心轴升降圆盘调节工件到适当的高度，并锁紧无心轴承；
7.用工件挡杆调好工件伸出的长度；
8.用左右移动杆慢慢将研磨棒伸进工件内，然后用左右行程挡块固定好研磨棒向左边移动的距离；
9.转动研磨棒移动圆盘，将研磨棒慢慢靠近工件；
10.打开电源开关，打开研磨棒马达开关，及打开无心轴承开关；
11.慢慢转动研磨棒进给圆盘，当研磨棒碰到工件后，将左右移动杆左右匀速移动，使研磨棒研磨工件；
12.每次进刀为0.01—0.02mm，进刀时不可多快，加工中应多次测量；
13.加工完后，做好机台的卫生及保养。

中译英：
1 inspection machine parts are normal;
2 according to the dispatch list required processing requirements, select the appropriate grinding rod;
3 grinding rod is installed on a motor shaft;
4 the workpiece is placed in a bearing, and a bearing rod workpiece clamping;
5 the dial indicator is used to check whether a workpiece is level, such as slope, slope angle adjustment screw with0 degrees inclination adjustable;
6 open without bearing lifting switch, with no mandrel lifting disk adjusting the workpiece to the proper height, and the locking without bearing;
7 bar adjustable workpiece workpiece for extending the length of;
8 move around the rod slowly grinding rod into the workpiece, and then use the left and right stroke chock block is fixed to the moving distance of the grinding rod left;
9 the rotating grinding rod moving disc, the grinding rod slowly around the workpiece;
10 turn on the power switch, open the grinding rod motor switch, and a switch to open bearing;
11 the rotated slowly grinding rod feed disc, when the grinding rod encountered after the workpiece, will move the lever to the left to move at a constant speed, so that the grinding rod grinding workpiece;
12 each feed for0.01 0.02mm, feed can not be fast, processing should be measured for many times;
13 after the operation, good health and maintenance machine.
(图/文http://www.wxxinghua.com/)